Neuer EMS Auto Carrier Autotransporter Auflieger

Auto Carrier TECHNICAL INFORMATION

• Capacity: Our production has an 8-auto carrying capacity.

• Type: Our production is of solid type.

• Main chassis: Will be produced from ST52 "I" sliced iron sheet.

• Side chassis: Upper platform supported with 120 x 80 x 5 profile, front and rear NPU 140, back traverses NPU 65.

• Platform System: Rear platform system with hydraulic and mechanical system for auto entrances.

• Hydraulic Cylinder: For upper platform movement, 1 hydraulic cylinder with 100 x 100 x 1300 stroke 130 cm, 4 bottom level movable, 1 upper level, and 1 rear ramp system. A total of 7 hydraulic systems.

• Platform Corners: Will be produced from 6 mm ST 37 quality special press iron sheet. Pulleys and ropes will be installed inside the pillars to enable movement of the upper platform.

• Flooring: Covered with 3mm non-slip oval type perforated sheet.

• King-Pin: Will be 2" thick and certified with an "E" label in compliance with DIN norms.

• Landing Gear: Two mechanical landing gears with a carrying capacity of 25 tons each, local brand.

• Axle: Local axle group with dual tires, each with a 9-ton capacity (drum brakes).

• Air Suspension: Equipped with air suspension bellows and parabolic Z leaf springs.

• Shock Absorbers: Shock absorbers to limit excessive axle movement.

• Brake Adjusters: Automatic brake adjusters.

• Brake Chambers: 24" service chamber, 24 x 30 emergency brake chamber.

• Brake System: ABS (WABCO), imported automatic load sensing valve with circuit filter, two-line air brake system, air suspension front axle lift, and brake circuit with air provided by two large air tanks. Imported polyamide pipes will be used in the air circulation system. Compliant with EU standards (4S 2M).

• Ramp Adjustment Control: Raise-Lower Valve (WABCO).

• Electrical System: 7-pin, EEC standard 24V.

• Paint: 2 coats of epoxy primer, 2 coats of topcoat. First-class acrylic oven paint in the color requested by the customer.